Eagle Tree Systems ECU-JETCAT Manuel d'utilisateur télécharger pdf

http://www.eagletreesystems.com

Instruction Manual for the Seagull Jet ECU Interfaces

Document Version 1.2

Model #’s ECU-JETCAT, ECU-AMT, ECU-FADEC

Thank you for your purchase! This instruction manual will guide you through the installation and operation of your Seagull

Jet ECU Interface. Please read the entire manual carefully before proceeding. If, after you read the manual (including the

Troubleshooting section!!), you have further questions or problems, see the Support page on

http://www.eagletreesystems.com

for additional information, or email us at [email protected].

Features and Benefits of the Jet ECU Interface

The Jet ECU Interface, in conjunction with our Seagull Pro Flight System, provides real-time data and audible feedback

about the state of your Model Jet, while you are flying! Think of the Jet ECU Interface as a Wireless Engine Data

Terminal/GSU for your Jet.

Data such as ECU Turbine RPM, Turbine temperature, Throttle %, ECU Pack and Pump Voltage, and ECU status

messages are retrieved from your ECU and transmitted wirelessly to the Seagull Dashboard. Audible alarms can be

programmed for low Turbine RPM and temperature for early flameout alert, and for ECU pack voltage for low battery

indication. All these parameters are in addition to the standard data parameters that are available on the Pro System.

In addition to display on the LCD screen of the Wireless Dashboard, if the Dashboard is connected to a laptop via USB,

all the ECU data are available live with the Windows Virtual Cockpit application!

Packing List

Your package should include the following: Jet ECU Interface Cable (either AMT Netherlands, JetCat or FADEC), and a

printed version of this manual. Please check your box for printed addenda to this manual which may be included if

changes were made after printing.

Requirements

The Jet ECU Interface requires a Seagull Pro Flight System, with Windows application version 3.39 or later. The latest

version is available on the support page of our website. The Recorder and Dashboard firmware needs to be updated using

“Tools, Firmware Control.”

For JetCat users, version 4.00g of the JetCat ECU is required. For AMT Netherlands users, the Recorder must be

powered with a 4 cell (4.8v pack).

Do you have an ECU that is not currently supported? If so, email us at [email protected]

and we may be able

to help!

How the Jet ECU Interface Works

The Jet ECU Interface cable plugs between the Pro Flight Recorder the data/telemetry port of your ECU. After simple

Windows configuration, the Recorder reads the ECU parameter data and transmits it to the Wireless Dashboard.

1 2 3 4

Page 1

Page 3

Pas de commentaire

Eagle Tree Systems ECU-JETCAT Manuel d'utilisateur